Brennan Anderson Photography Brennan Anderson Photography

Elinchrom ELB 500 Review

Gear review: Elinchrom ELB 500

View this post on Instagram

A post shared by Brennan Anderson (@anderson_brennan_) on Nov 27, 2018 at 5:11pm PST


That’s the cost of the Ikea coffee table that was crushed by a tumbling 6.61-pound Profoto B1 monolight. While I quickly got over the damage to my table, the incident got me thinking about my lighting kit situation. I did a bit of research on portable, powerful lighting options before discovering the Elinchrom ELB 500 TTL Dual To Go Kit. After selling my B1s, I decided to give Elinchrom a try and picked up the ELB 500 and a couple of flash heads.

How does the pack perform? Am I happy with my decision to switch kits? Read on to find out.

Size and build quality

View this post on Instagram

A post shared by Brennan Anderson (@anderson_brennan_) on Nov 19, 2018 at 10:57am PST

The ELB 500 is as portable as it gets for a pro lighting kit. The pack itself weighs 5.5 pounds, but the heads weigh a mere 1.5 pounds. How’s that any better than my 6.61-pound monolight? Allow me to explain.

Unlike my old Profoto B1s, the ELB 500 is a pack and head kit, meaning the power pack and flash heads are separate but attached by a cable. Most of a pack and head system’s weight lives in the pack, which typically sits on the ground or helps weigh down a light stand. On the other hand, the flash heads are small and carry very little weight. In the case of the ELB 500, its flash head weighs about as much as a typical speedlight, yet it can produce 500Ws of power. The heads are incredibly small and work perfectly with my 59" Rotalux Inverse Octabox and 39" Rotalux Deep Octabox.

Adjusting a boom arm rigged with a 1.5-pound flash head and modifier is a lot easier and safer than it is with a monolight that weighs over 5 pounds.

Battery life and power options

View this post on Instagram

A post shared by Brennan Anderson (@anderson_brennan_) on Oct 12, 2018 at 12:37pm PDT

The ELB 500’s battery fires up to 400 flash bursts at full power. Lower the power, and you’re good for thousands of flashes.

Another great thing about the ELB 500 is that it can trickle charge. If you’re out on location all day and run down the battery before heading to your studio for an indoor shoot, plug your pack into an AC outlet and keep shooting without pause. No more running out of power in the middle of a shoot, and feel free to leave your modeling lights on.

Because the B1s don’t have trickle charging, the only workaround is to buy more batteries, and at $304 a pop, that option is far from ideal.

Two heads, without the hassle

View this post on Instagram

A post shared by Brennan Anderson (@anderson_brennan_) on Dec 7, 2018 at 9:17am PST

Unlike with the ELB 400, shooting with both ports works seamlessly. The ELB 500 offers full asymmetry, meaning both ports can be controlled fully independently. Also, I’ve found that 500Ws split between two heads provides enough power for my style of studio shooting. The only downside to using both ports is that the flash head cables are quite short, meaning without a Q-Extension cable, head placement is limited.

Unknown potential

View this post on Instagram

A post shared by Brennan Anderson (@anderson_brennan_) on Nov 26, 2018 at 3:57pm PST

Because I shoot with a Fuji camera, I’m not yet able to use some of the ELB 500’s biggest selling points: HSS (high-speed sync), HS (hi-sync), and TTL (through the lens metering). However, Elinchrom recently announced that the Skyport Transmitter Pro for Fuji will hit shelves this September.

While I’ve always used manual instead of TTL flash and don’t plan to use the TTL functionality, I’m excited to pack up my ELB 500 kit, head outside and shoot with HSS.

I’m currently shooting with a basic Skyport trigger, and it works well, but the Skyport Transmitter Pro looks a lot more sophisticated. I’ll provide an update once I get my hands on the Fuji version of the Transmitter Pro. That being said, the Profoto Air Remote was probably my favorite part of the B1 system, and I think it’d be hard for the Transmitter Pro to beat its ease of use.

Thoughts? Questions? Let me know.